Polyurethane Adhesive for Rubber Flooring — Eagle Grip (4 Gallon)

Polyurethane Adhesive for Rubber Flooring — Eagle Grip (4 Gallon Pail)

Not all adhesives work with rubber flooring — and using the wrong one means callbacks, failures, and flooring that lifts at the edges. The Eagle Grip Polyurethane Adhesive is a single-component, trowel-applied adhesive specifically formulated for rubber flooring installation. It requires no moisture testing, bonds to a wide range of subfloors, and holds up to both indoor and outdoor exposure.

One 4-gallon pail covers approximately 300 square feet of rubber flooring when applied with a V-notch trowel. If you’re doing a full glue-down installation on a rubber roll floor, this is the adhesive for the job.

Key Features

• No moisture testing required — saves time on concrete slabs where moisture readings are typically required before adhesive installation; Eagle Grip handles it without the extra step (with sound control applications)
• Wet-set, early grab, fast-curing formula — positions quickly and holds firmly so you can stay on schedule; no waiting around for it to reach a specific tack level
• High-strength, waterproof bond — resistant to moisture and water exposure after curing; suitable for below-grade, at-grade, and outdoor covered installations
• Non-staining and easy to clean — cleans up without leaving residue on the flooring surface if applied carefully
• Indoor and outdoor use — bonds rubber flooring in gyms, weight rooms, garages, commercial spaces, and covered exterior applications

Coverage & Application

• Coverage: 1 gallon covers approximately 75 sqft | 4 gallon covers approximately 300 sqft
• Application method: Spread with a V-notch trowel (1/8” x 1/8” x 1/8”) for correct adhesive depth and uniform coverage
• Approved flooring types: Rubber flooring, engineered flooring, solid hardwood flooring
• Subfloor compatibility: Concrete, wood, and a variety of other surfaces

Measure your room before ordering: divide total square footage by 75 to calculate gallons needed, then round up to the nearest whole gallon.

What You’ll Need for a Glue-Down Rubber Flooring Install

• Eagle Grip Polyurethane Adhesive — this product; 1 gallon per ~75 sqft
• V-Notch Trowel — required for spreading adhesive at the correct depth and coverage rate
• 48” T-Square — for straight layout lines and edge cuts before laying flooring into adhesive
• Utility Knife — for cutting rubber rolls to length and at perimeter edges

Safety Data Sheet

Download the Eagle Grip Polyurethane Adhesive Safety Data Sheet (PDF) for handling, storage, and ventilation requirements before installation.